USB FLASH DRIVE CANNOT READ FILES/MOVIES ON TV AFTER USING IT AS BOOTABLE

Well, as the title says, it might be frustrating for some even you already formatted your USB drive over and over again but still can't read files thru your tv, but not after all after reading this article, although Google has an answer for it but doesn't elaborate on how to do it, the noobs style, here is a simple yet EFFECTIVE WAY to use your usb flash again in watching movies thru it.  The culprit in this problem was the GPT (Gui Partition Table) since most of the new PC today required a GPT instead of MBR (Master Boot Record) in formatting a Wimdows.

Things needed:

• RUFUS (portable version so no need to install)
• PC
• your USB flash drive

Here we go:

• Insert your USB flash drive into any usb port of your PC 
• Back up all the necessary files in your USB flash, because we will be wiping out all your files by formatting it
• Open RUFUS and follow these steps,

                     >  Select MBR partition scheme for UEFI

                     >  Select NTFS

                     >  Uncheck bootable disk using..

                     >  Uncheck create extended label and icon files

                     >  Lastly click Start and wait, you do the math.

How To Combine/Connect Two or More ISP Into Single Internet Connection

Noobs Definitions of Terms:
ISP = Internet Service Provider (Example: Smart, Globe, PLDT, etc..)

Things Needed:
>  Two Internet Provider (example Globe + Smart, or Globe + Globe, or Smart + Smart, you get the math)
>  Connectify Installer (download from here)
>  PC/Laptop
>  Wireless dongle and or another LAN card for desktop
>  Common Sense

Instructions:
>  Disconnect from Internet first
>  Install the latest version of Connectify (but in this tutorial I prefer the old version 7.3.0.30245 Pro since it's more stable than the latest version and the good thing with it, we can crack it into PRO)
>  Finish the entire installation
>  Now launch Connectify Activator
>  Click Activate PRO button
>  Activator will show a message box saying Connectify successfully activated
>  Wait 1 minute and Launch Connectify

That’s it you are ready to go with Connectify PRO ! Launch Dispatch and make sure its PRO too


NOTES:
For LAN + LAN

Mostly dito nagkaka roon ng problema when using Connectify Dispatch, IP address of each modem should have a different IP to be able to synchronize the two internet connection into single connection. Example, if the first modem has an IP or 192.168.254.254 the second modem should not have the same..so you need to change the modems IP, In short dapat walang magkaparehong IP ang modem, example ulit, if the first modem has an IP of 192.168.1.1 the second modem should be 192.168.2.1 para hindi IP conflict.

For LAN + Wifi
No need to change wifi modems IP if conflict with the first modem that is connected via LAN port.


Here's my setup Smart @ 2mbps combining with Globe @ 2mbps (LAN+LAN)